Introduction - Renson Cbase Instrucciones De Montaje

C
base
en
1 • Introduction
Important! Read these instructions before installing the Cbase
Do not install this product in rooms where it can be exposed to
the following conditions:
• A greasy atmosphere
• Corrosive or flammable gasses, fluids or vapours
• Room temperatures above 40°C or lower than -5°C.
• Relative humidity higher than 90% or outside
• Obstacles that obstruct the access to or the removal of the ventilation unit
• Bends in the ventilation duct close by the ventilation unit
• The Cbase cannot be connected to a motorised cooker hood or dryer
®
Safety instructions:
A. All wiring has to be done by a qualified person.
B. Make sure that the electric power supply is 230V, 1 phase, 50Hz.
C. The ventilation unit can only be used with the appropriate RENSON
controller.
D. the installer needs to make sure that the ventilation unit is put at at least 600mm distance of a
chimney.
E. The ventilation unit is not to be used in areas where it may be exposed to water.
G. the exhaust of the ventilator always has to be directed outside.
General safety measures
Always take the following safety regulations into consideration when installing the Cbase
compliance can result in damaging the appliance or in personal injury. RENSON
accountable in such situations.
• The installation of the Cbase
construction, safety and installation regulations.
• Only a qualified RENSON
maintenance on the system other than the basic maintenance procedures mentioned in this
manual.
• Always take the safety instructions, warnings, remarks and instructions in this manual into
account.
• Keep this booklet near the Cbase
• Modifications to the Cbase
• Maintenance instructions need to be taken into account in order to prevent damage and/or
wearing. It is recommended to sign a maintenance contract ensuring a regular check-up and
cleaning of the appliance.
• The appliance needs to be installed in a way that prevents accidental contact. This means that
under normal circumstances nobody should come in contact with the live components without
performing a conscious action such as:
- Taking off the lid without proper tools
- Removing the motor of the fan after removing the lid with proper tools
- Removing a ventilation duct or control valve while the system is operating.
42
®
has to be performed in accordance with general and local
®
installer can install the Cbase
®
.
®
are not allowed.
®
®
accessories, ducts and
®
®
, connect, start up and perform
®
. Non-
®
cannot be held