Cleaning And Maintenance; Changing Light Bulbs - Teka DHT 120 Manual De Instrucciones

Program the working time
• Turn the hood on and select the required
extraction speed
• Select the programming time by pressing
Timer.
• Each press of the button increases the
programming time by 10 minutes, up to a
maximum of 80 minutes.
• To reset the programme, wait for over a
second and press the Timer button again.
• The speed a nd extraction time are displayed
with the LED indicator.
• The intensive speeds 6, 7 and 8 cannot
be programmed. These must be selected
manually and have a maximum duration of
approximately 10 minutes.
Filter saturation indicator "F"
• Clean the filters when all lights of the
LED indicator begin to flash followed by
an acoustic signal.
• Press "Filter Saturation" to reset this
feature

Cleaning and maintenance

During cleaning and maintenance
work, make
instructions are complied with.
Cleaning the hood body
• If your kitchen hood is made of
stainless steel, use proprietary cleaners
mentioned in the product instructions.
• If your kitchen hood is painted, use
lukewarm water and a neutral soap.
• Never use metallic scourers, nor
abrasive or corrosive products.
• Dry the kitchen hood using a cloth that
does not produce fibres.
• Do not use vapour cleaners
sure the safety
Cleaning the metal filters
• To remove the filters from their fittings,
press lightly on the locks and then pull
them off.
• The metal filters can be cleaned by
soaking them in hot water with neutral
detergent until the fat dissolves and
then rinsing them under the tap or using
special anti­grease products. They can
also be washed in a dishwasher. In
this case, it is advisable to stack them
vertically to avoid food residues to stick
to them.
• Cleaning in a dishwasher may damage
the metallic surface (blackening it),
although this will not affect its fat
retention capacity.
• Once clean, leave them to dry off and
then fit them onto the kitchen hood.

Changing light bulbs

Proceed as follows:
• Unscrew the lamp cover.
• Change the broken / burnt out lamp.
• Screw the lamp cover back in.