Bosch PSR 200 LI Instrucciones De Servicio página 29

OBJ_BUCH-88-003.book Page 29 Thursday, December 14, 2006 10:30 AM
Position 1:
Lower torque for screwing in screws with small diameter or into
soft materials.
Position 6:
Higher torque for screwing in screws with large diameter or into
hard materials.
Switching On and Off
To start the machine, press the On/Off switch 8 and keep it
depressed.
The power light 10 lights up when the On/Off switch 8 is slightly
depressed, and enables illumination of the screwing location in
unfavourable light conditions.
To switch off the machine, release the On/Off switch 8.
Fully automatic spindle locking (Auto-lock)
The drill spindle is locked when the On/Off switch 8 is not
pressed.
This enables screws to be screwed in, even when the battery is
empty and allows for the machine to be used as a screwdriver.
When the drilling spindle is locked, do not press the
On/Off switch 8 for more than 15 seconds. Otherwise
the power tool can be damaged.
Operating Instructions
Apply the power tool to the screw only when it is
switched off. Rotating tool inserts can slip off.
Soft Grip
The gripping surface (soft grip) 7 reduces the danger of slipping
and thereby improves the grip on the machine and the handling.
At the same time, the rubber coating achieves a vibration-reducing
effect.
2 609 001 148 • 14.12.06
English | 29