Set Up - Selecting The Mode For Acquiring Wheel; Dimensions In Balancing Programmes Alu1 And Alu2 - SICE S 62 E Manual De Instrucciones

- tighten the screws on the adapter making sure that it
rests on the flange correctly;
- mount the motorcycle shaft on the adapter;
- mount the wheel after selecting the centring cones (one
for each side of the wheel), tighten with the appropriate
ring nut using the spacers necessary for coupling the
securing cones to the threaded part of the shaft.
- mount the relative extension (Fig.22) on the internal
measuring arm.
- set the wheel data as shown in the paragraph "Enter-
ing wheel dimensions".
Important
the wheel must be fixed to the flange so as to avoid any
movement of the two during the spin or braking phases.
Best results can be achieved if the adhesive weights are positioned with the outer edge
flush with the rim edge.
15.2. SET UP – SELECTING THE MODE FOR
ACQUIRING WHEEL DIMENSIONS IN THE
ALU1 AND ALU2 BALANCING PROGRAMMES
(ONLY THE MACHINE VERSION WITH
This configuration is used to select the method for entering dimensions for the ALU1 and
ALU2 programs and as a result the method of applying the adhesive weights inside the rim.
Proceed as follows to recall this programme:
- press the
- use the
- press the
- use the
- press the
or ALU P: to activate the ALUP balancing programmes. These programmes are used for maximum
106
MANUAL SENSOR)
key
keys to search for SEt UP
key to confirm
keys to search for ALU P (or ALU St if previously set)
key to change the setting:
S 62 E Operator's manual
22