SICE S 62 E Manual De Instrucciones página 99

To use this programme, proceed as follows:
1 Turn the wheel until the central element of the corresponding position indicator lights
up.
It is recommended to keep the wheel in position using the pedal brake.
2 Press the
Programme activation is indicated by the illumination of the LED
display panel.
3 If the weight-holder device is present, turn the wheel again until the central element
of the outer side (Pe) position indicator lights up.
4 Turn the wheel to the point where the first outer weight (P1) should be applied behind
a spoke. The machine will display the following message:
To select the exact position of the weight P1 relative to the Pe unbalance, use 6 o'clock
as the reference if the "LAS" configuration is active and 12 o'clock if the "H12" or "CLP"
configuration is active.
The angle between P1 and Pe must be less than 120°.
5 Press the
6 Turn the wheel to the point where the second outer weight (P2) should be applied
behind a spoke. The machine will display the following message:
To select the exact position of the weight P2 relative to the Pe unbalance, use 6 o'clock
as the reference if the "LAS" configuration is active and 12 o'clock if the "H12" or "CLP"
configuration is active.
The angle between P1 and P2 must be less than 120° and must include the outer
weight Pe.
7 Press the
8 Turn the wheel manually and the two unbalance values calculated are displayed in
alternation on the display regarding the outer side as the angular position of the wheel
changes. Each of the two balancing weights is applied as described in the chapter
"Applying balancing weights in ALU1P or ALU2P balancing programmes".
The Hidden Weight function is combined with the SHIFT PLANES function to allow
S 62 E Operator's manual
key to activate the programme.
key to memorise the first spoke.
key to memorise the second spoke.
on the
99