Switching On The Machine - SICE S 62 E Manual De Instrucciones

KEY
3
4
5
6
7
1. SWITCHING ON THE
MACHINE
Connect the power supply cable (A, Fig.10) supplied
with the machine from the external electrical panel
located on the rear side of the wheel balancer body
to the mains.
Switch on the machine using the switch on the rear
side of the body (B, Fig.10).
The wheel balancer performs a checking test (all the
LEDs illuminate), and if no faults are detected, a
beeper sounds and the cycle status initially active
is displayed, as follows:
S 62 E Operator's manual
Multifunction key
1. In balancing mode, press this key to select the
Internal weight
selection/De-
crease 2. In the menu press this key to navigate.
3. When entering dimensions manually, press this
Multifunction key
1. In balancing mode, press this key to access the
Menu / Enter
2. In a menu or in a program, press this key to
Multifunction key
1. In balancing mode, press this key to select the
Outer weight
selection/In-
crease 2. In the menu press this key to navigate.
3. When entering dimensions manually, press this
Start - Press this key to perform a spin.
Stop - Press this key to stop the spin.
DESCRIPTION
type of weight to use on the inner side of the
wheel.
key to decrease the displayed value.
wheel balancer menu.
change the viewed option.
type of weight to use on the outer side of the
wheel.
key to increase the displayed value.
10
83