SICE S 62 E Manual De Instrucciones página 87

set values.
After completing the wheel data update, press the
unbalance values recalculated according to the new dimensions, or to perform a wheel spin.
- if two subsequent measurements are taken inside the rim on two balancing planes, the
machine interprets the presence of a rim with balancing using a clip weight on the inner
plane and an adhesive weight on the external one (ALU 2P).
In this phase, the machine could automatically
change the type of weight on the inner plane from
clip to adhesive (ALU 1P). The operator is able
to change this setting by pressing the
key. In this case, the balancing programme
switches from ALU 1P to ALU 2P and vice versa.
S 62 E Operator's manual
button to exit and display the
or
11b
12
87