Set Up - Unbalance Unit Of Measure - SICE S 62 E Manual De Instrucciones

precision balancing on light aluminium rims that require the application of both weights on the
same side (inner) in relation to the rim disk. This type of wheel balancer is particularly suitable
for application of adhesive weights on the rim, thanks to the forward position of the wheel in
relation to the body, which allows a large zone on the inside of the rim to be accessed freely.
To enter the dimensions and apply the weights, refer to the paragraphs with ALU 1P – ALU2P
or ALU St: to memorise the rated dimensions of the rim. Self-adhesive weights are generally
used to balance alloy wheels and are applied differently than for standard balancing. Several
ALU balancing programmes are available, specially designed for these types of rim. To enter
the dimensions and apply the weights, refer to the paragraphs "Entering wheel dimensions
(ALU1P and ALU2P programmes excluded)" and "Applying balancing weights"
- press the
15.3. SET UP - UNBALANCE UNIT
The machine may be set to display the unbalance values in grams or ounces. Proceed as fol-
lows to modify this configuration:
- press the
- use the
- press the
- use the
is active)
- press the
Unb Gr to activate the unbalance display in grams
or Unb Oun to activate the unbalance display in ounces
- press the
It is possible to quickly set the unit of measure in grams or ounces by pressing and holding
the key for at least six seconds
S 62 E Operator's manual
key to confirm and exit.
OF MEASURE
key
keys to search for SEt UP
key to confirm
keys to search for Unb Gr (or Unb Oun if the ounce display mode
key to change the setting:
key to confirm and exit.
107