Set Up - Laser Indicator (If Provided) - SICE S 62 E Manual De Instrucciones

LEd oFF to disable the lighting device
or LEd 1 to activate the lighting device when acquiring dimensions during an
ALU1 P or ALU2 P balancing programme, at the end of a spin cycle in
the case of residual unbalances for 30 seconds, in CP (centred position)
for an additional 30 seconds
or LEd 2 in this configuration, the light will turn on, in addition to the situations
indicated above (in the Led1 mode) also during the entire measurement
cycle, when acquiring dimensions in all balancing programmes and in
the Hidden Weight programme when selecting the two planes behind
the spokes.
- press the
15.13. SET UP - LASER INDICATOR
The machine allows the operator to enable or disable the laser device.
Proceed as follows to make this setting:
- press the
- use the
- press the
- use the
- press the
LAS on to enable the laser device
or LAS oFF to disable the laser device
- press the
Caution
If the laser indicator is enabled, the application of the adhesive weights (except for
the ALU1 P and ALU2 P balancing programs with the weight-holder device present)
and the reference for selecting the two weights behind the spokes (Hidden Weight) is
at 6 o'clock (H.6).
S 62 E Operator's manual
key to confirm and exit.
(IF AVAILABLE)
key
keys to search for SEt UP
key to confirm
keys to search for LAS on (LAS oFF if previously set)
key to change the setting:
key to confirm and exit.
115