Hella 2PS 008 643-011 Instrucciones De Montaje página 16

GB
Installation:
- Fit the bracket to the vehicle (pages 4/5/6)
- At the point where the lamp is to be fitted, the cable must be clean, dry, and free of
grease and oil. There must be no dirt or bore chips on the surface.
- Remove the protective film from the adhesive tape (page 7)
- After removing the film, the lamp must be fitted within 5 minutes.
- Lay the cable in the guide on the lamp and press in (page 8)
- Lock the sealing cap into place (page 9)
16
- Tighten the screws evenly with the torque specified above (page 9)
- Carry out a visual check to see if the screws and sealing cap are lying flush (page 9)
- Lay the cable in the strain relief devices on the bracket (page 10)
Notes:
- When replacing a lamp, the new lamp must be fitted to the existing incision points
(page 11)