GENERAL MENU
2
1
1
2
3
3
SET POWER
TEMPERATURE SET
USER MENU
SET CHRONO
STATUS
**STOVE STATUS
SETTINGS
** TECHNICIAN
MENU
BASIC INSTRUCTIONS
� The following recommendations must be followed the rst
times the stove is ignited:
� Faint smells may be produced due to the drying of the paints
and silicones used. Do not remain in the environment for long
periods.
� Do not touch the surfaces as they could still be unstable.
� Air the room well several times.
� The hardening of the surfaces is terminated after several
heating processes.
� This appliance must not be used to burn waste.
The company has an optional additional board that allows the boiler the following further functions when managing the system.
The table below indicates the various possibilities that the optional can o er.
DHW Storage Management
Pu er Management
3 heating areas
Instant DHW option
Pu er pump or 4th heating area management
Anti-legionella management for DHW storage
DHW storage chrono management
Auxiliary output management and control
4
6
6
4
OFF
5
6
POWER
SET CLOCK
LANGUAGE
DISPLAY
STAND BY
SAME STEPS FOR THE OTHER ONES
1
Go back - exit
2
3
Parameter scrolling: next (2) ; previous (3)
Modify settings data: increase (4); decrease (5)
4
5
5
Con rm - access Menu
6
ENABLE CHRONO
ENABLE PRG1
ENABLE PRG2
ENABLE PRG3
ENABLE PRG4
START PRG1
STOP PRG1
MONDAY PRG1...
...SUNDAY PRG1
SET PRG1
3 TIME SLOTS
� Before lighting the stove, the following points must be veri ed:
� The hydraulic system must be completed in compliance with the
guidelines of the regulations and the manual.
� The tank must be full of pellets.
� The combustion chamber must be clean.
� The burn pot must be completely free and clean.
� Check the hermetic closure of the re door and the ash drawer.
� Check that the power supply cable is connected correctly.
� The bipolar switch in the rear right part must be positioned on 1.
ENGLISH
ROOM AIR TEMP SET
H2O TEMP SET
*ENABLE V1
* AIR V1
RESET
EASY SET UP
* WHERE PRESENT
** RESERVED TO THE
TECHNICIAN
p
p
p
p
p
p
p
p
43