General Menu; General Warnings - Dal Zotto INSERTO IDRO 800 Manual Del Usuario

GENERAL MENU

KEY FUNCTION
Scroll parameters
Modify settings
On - o key
OK
OK
SET
OK
SET CHRONO
SETTINGS
*STOVE STATUS
* TECH MENU
**SYSTEM SET
**SYSTEM STAT
The company has an optional additional board that allows the appliance the following further functions when managing the system.
Successively, the various possibilities that the accessory can o er.
p DHW Storage Management
p Bu er management
p 3 heating areas
p Instant DHW option

GENERAL WARNINGS

Advice to follow for the rst start-ups of the product:
During the rst hours of operation, there may be some smoke or
odours, but they are due to the normal "thermal break-in" process.
During this process, the duration of which changes depending on
the product, it is recommended to:
Š Ventilate the room well
Š If present, remove any majolica parts from the top of the
product
Š Activate the product at the maximum power and temperature
Š Avoid remaining in the room for a long time
Š Do not touch the surfaces of the product
Notes:
The process is completed after a few heating/cooling cycles.
Do not use for the combustion of elements or substances other than
those indicated in the manual.
KEY
OK
DATE/TIME
LANGUAGE
DISPLAY
STAND BY
FIRST LOAD
OUTLET AIR
SET DEGREES
CLEAN.EXCHANG.
RESET
p Bu er pump or 4th heating area management
p Anti-legionella management for DHW storage
p DHW storage chrono management
p Auxiliary output management and control
Before turning on the product, it is necessary to perform the
following checks:
Š If it is intended to be connected to a hydraulic system, it must
be complete and fully functional and in compliance with the
instructions given in the product manual and with the relevant
regulations in force.
Š The pellet hopper must be completed loaded
Š The combustion chamber and the burn pot must be clean
Š Make sure that the re holder, the ash pan and the pellet
hopper close hermetically (if present in the hermetic version); they
must be closed and there must be no foreign bodies in the sealing
elements and gaskets.
Š Check that the power cord is properly connected
Š The bipolar switch (if present) must be set to position "1".
ENGLISH
FUNCTION
Back - exit key
Access menu key
ENABLE CHRONO
SET PRG 1
SET PRG 2
SET PRG 3
SET PRG 4
**WITH SYSTEM EXPANSION BOARD ONLY OPTIONAL
POWER
AMBIENT TEMP.
H2O TEMP.
VENTILATION
EASY SETUP
*TECHNICIANS ONLY
63