Safety Indications; Symbols; Safety Instructions - Quality Espresso STEAM CUBE Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

1.

Safety Indications

1.1 Symbols

WARNING
!
May cause injuries.
INFORMATION
i
Important or useful information.
RISK OF ELECTRIC SHOCK
May cause injuries.
We ask you to carefully read this instruction manual before operating your new water/steam
dispenser for the first time.
Keep these instructions in a safe place where you can consult them when necessary.
The inappropiate use of this machine exempts Quality Espresso from any liability.

1.2 Safety Instructions

Installation
Transport
Storage
EN
Placement
The Dispenser should only be installed by authorized technical
personnel. The manufacturer declines any liability for possible
injuries caused by inappropriate installation.
The Dispenser should only be installed in places where its use and
maintenance are restricted to qualified personnel.
The Dispenser should be installed hydraulically and electrically
according to the regulations in force at the place of installation.
The Dispenser can work at temperatures between 7ºC and 35ºC,
and in those places where the temperatures are bearable for people.
The use of gloves is recommended to manually move the machine
to its installation site.
In the event of storage or transport of the machine in temperatures
lower than 0º C, and in order to prevent freezing, the Dispenser's
hydraulic circuit should be emptied first.
In the event of freezing, the Dispenser should be placed in an area
with a temperature higher than 10º C to wait for unfreezing. Under
no circumstances should the machine be connected to the electrical
circuit before it is unfrozen.
The Dispenser should be stored in areas with a temperature higher
than 5º C.
It is recommended that the Dispenser is installed in a spacious area,
free of air currents and with a solid base. Avoid installing the
machine on a wet or hot surface.
Regulate the height of the Dispenser with the support legs.
Maximum inclination cannot be greater than 1º between any of its
axes.
29

Publicidad

Tabla de contenido
loading

Tabla de contenido