Installation; Machines With Mains Water Connection - Quality Espresso STEAM CUBE Manual De Instrucciones

3.2 Installation

3.2.1 Machines with mains water connection

Once the machine has been unpacked, the following steps should be performed:

Check that the electricity supply voltage is the same as
that listed on the specification plate and in the
machine's documentation.

Place the machine on the workbench, and
1
connect the water supply tube from the
stopcock (1) to the water softener (2).

Drain the output of the water softener into a
bucket, until the water flows clean.
It is recommended to use water with a hardness
i
between 5-8 dHº (8-14 fHº) to avoid calcification and to
obtain an optimal quality of the product.

Connect the plug to the appropriate socket
3
according to the current electrical standards
of the area.
EN
You should not use extension cords or outlet adapters
i
of any kind to connect the machine to the electricity
network.
The network connection cable should never be rolled
up; instead, it should be fully extended to avoid
possible overheating.

Connect the output of the water softener to the
2
machine's water input (3).

Supply water by opening the stopcock (1).

Open the steam tap.

Press the main power switch.
4
Main switch
- At this moment the boiler will automatically fill with water,
a process that is indicated by the led located next to the
main power switch.
Once the filling process has finished, the indicator will turn
off and the boiler heating cycle will start. This process lasts
for approximately 15 minutes, and at this moment the
steam tap should be closed.
After this time and with pressure reading of approximately
1.3 bars on the gauge, the machine is ready to work.
If an adequate water level is not detected in the boiler within
i
a certain time, the water level LED indicator (next to the
main power switch) will blink, indicating a water level
warning. This warning can be cancelled by turning the
machine off and on again.
33
3
Water level LED
Indicator