Resetting The Unit; Maintenance / Cleaning - Bresser MyTime Duo 80-10020 Instrucciones De Uso

Set single alarm
Press SET button (5) enter Alarm mode.
Press and hold the SET button for 2 seconds in the Alarm
mode to enter the setting mode.
The hour will begin to blink. Press the
to reach the desired hour. In 12hr mode the PM indicator
will light for afternoon hours.
Press the SET button again. The minute will begin to blink.
Press the or button to reach the desired minute.
Press the SET button again. The time interval display for
the snooze function will begin to blink. Press the
button to reach the desired time interval (1-20 minutes are
available).
Press the SET button again to exit the single alarm setting
mode.
Activate or deactivate single alarm
Enter the Alarm mode by pressing the SET button (5) once
in the Time mode.
Press the
The alarm symbol

RESETTING THE uNIT

(3) or button (4)
In case of malfunction or abnormal display, take out and
re-install the batteries again. All settings will be cleared
and reset to their default values.
mAINTENANcE/cLEANING
or Before cleaning the device, disconnect it from the power
supply (remove batteries).
Only use a dry cloth to clean the exterior of the device.
To avoid damaging the electronics, do not use any clean-
ing fluid.
Protect the device from dust and moisture. The batteries
should be removed from the unit if it has not been used
for a long time.
LED
(3) button to activate or deactivate the alarm.
will light up when the alarm is activated.
DE
GB
FR
NL
IT
ES
13