Automatic Re-Ignition; Power Failure; Flame Height; Flame Description - Thremador PRD304GHC Manual De Uso

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Automatic Re-Ignition

If any one or more burners blow out, the electronic igniter
automatically activates to re-light the flame. Do not touch
the burners when the igniters are active.
IMPORTANT:
For proper combustion do not use the cooktop without
the burner grates in place.
There is a slight sound associated with gas combustion
and ignition. This is a normal condition.
On cooktops using propane gas (LP), a slight "pop"
sound may be heard at the burner ports a few seconds
after the burner has been turned off.

Power Failure

I
n the event of a power failure, only the standard
burners can be manually lit. It is necessary to light each
one individually.
If the cooktop is being used when the power failure
occurs, turn all knobs to the OFF position.
The standard burners can be lit by holding a match at
the ports and turning the control knob to the HI
position. Wait until the flame is burning all around the
burner cap before adjusting the flame to the desired
height.
®
The ExtraLow
burners cannot be used during a power
failure. Be sure to turn them off.
If an ExtraLow burner is on when a power failure
occurs, it cannot be turned back on until the knob is
first turned off.
The griddle cannot be used during a power failure.
If you smell gas, refer to safety precautions listed on
page 1.
WARNING:
In the event of a power failure, turn all knobs to the OFF
position. Only the Standard burners can be lit manually.

Flame Height

The correct flame height depends on 1) size and
material of pan being used; 2) food being cooked; and
3) amount of liquid in the pan.
Never extend the flame beyond the base of the pan.
Use a low or medium flame for pan materials that
conduct the heat slowly, such as porcelain coated steel
or glass-ceramic.

Flame Description

The burner flame color should be blue with no yellow
on the tips. It is not uncommon to see orange in the
flame color; this indicates the burning of airborne
impurities in the gas and will disappear with use.
With propane (LP) gas, slight yellow tips on the primary
cone are normal.
The flame should burn completely around the burner
cap. If it doesn't, check that the cap is positioned
correctly on the base and that the ports are not
blocked.
The flame should be stable with no excessive noise or
fluttering.
WARNING:
This product contains or, through ordinary use for its
intended purpose, facilitates emission of chemicals or
other substances known to the State of California to
cause cancer and/or birth defects or other reproductive
harm. To minimize exposure to these chemicals:
®
1) The STAR
burners should be adjusted by a
certified installer or agency to ensure proper
combustion.
2) Ensure proper ventilation with an open window
or use a ventilation fan or hood when cooking
with gas.
3) ALWAYS operate the unit according to the
instructions in this manual.
Dark Blue
Dark Blue
Dark Blue
Secondary Cone
Secondary Cone
Secondary Cone
Light Blue
Light Blue
Light Blue
Primary Cone
Primary Cone
Primary Cone
Figure 18: Flame Color
English 15

Publicidad

Tabla de contenido
loading

Productos relacionados para Thremador PRD304GHC

Tabla de contenido