Range Cleaning - Thremador PRD304GHC Manual De Uso

To Set Self-Clean
1. Select SPEED CLEAN using the Mode Selector Knob.
2. Set Temperature Selector Knob to CLEAN.
• Cooling Blower turns on.
• OVEN ON, PREHEATING and CLEANING lights
turn on.
OVEN ON PREHEATING CLEANING
• When the oven reaches maximum self-clean
temperature, the PREHEATING light turns off.
NOTE:
T
he door closing process takes approximately 20 seconds
to complete, at which time the door becomes locked.
Check to make certain the door is locked.
At the End of the Clean Cycle
The Clean cycle takes 2 hours to complete. The OVEN ON
light and the CLEANING light turn off when the cycle is
finished. Do not turn either of the oven temperature knobs
to the OFF position until the automatic lock cycles to the
open position.
1. Select OFF using the Mode Selector Knob.
• The door latch will open automatically when the
oven is below 500°F (260°C) and the automatic
Door Lock completes its 60 second cycle to the
open position.
• The cooling blower turns off when the oven
temperature drops to 200°F (93°C).
2. Turn the oven temperature knob to OFF position.
Cleaning Tips
• The porcelain enamel finish is acid resistant, but not
acid proof. Acidic foods, such as citrus juices,
tomatoes, rhubarb, vinegar, alcohol or milk, should be
wiped up and not allowed to bake onto the porcelain
during the next use.
• Remove the oven racks. See Racks, on Range
Cleaning Recommendations, page 32.
• The heating elements in the oven do not require
cleaning; the elements burn themselves clean when
the oven is in use. Both elements are permanently
connected. It is not necessary to clean the broiler
shield above the broil element.
CAUTION:
The interior of the oven will still be at baking
temperatures when the automatic lock cycles to its open
position and the oven door can be opened.

Range Cleaning

When Cleaning This Range:
• Use the mildest cleaning procedure that will do the job
efficiently and effectively. Some cleaners of the same
type are harsher than others. Try on a small area first.
• Always rub metal finishes in the direction of the polish
lines for maximum effectiveness and to avoid marring
the surface.
• Treat stainless surfaces with a stainless steel polish
after cleaning to maintain and protect the finish.
• Use only clean soft cloths, sponges, paper towels,
fibrous brushes, plastic, non-metal or steel wool soap
pads for cleaning and scouring, as recommended on
the chart.
• Any part of this appliance can be cleaned with hot
sudsy water. When rinsing is required, rinse thoroughly.
• Do not use chlorine-based cleaners.
• Always wipe dry immediately to avoid water marks.
CAUTION:
Avoid cleaning any part of the range while it is hot.
Brand Names
The use of brand names is intended only to indicate a type
of cleaner. This does not constitute an endorsement. The
omission of any brand name cleaner does not imply its
adequacy or inadequacy. Many products are regional in
distribution and can be found in the local markets. It is
imperative that all products be used in strict accordance
with instructions on the package. The following chart gives
directions for cleaning this range.
English 31