Description - Hilti AG 125-A22 Manual De Instrucciones

Obligation signs
Wear eye Wear a hard
protection
en
Wear
breathing
protection
Symbols
Read the Return waste
operating material for
instructions recycling.
before use
Rated speed Revolutions
per minute

2 Description

2.1 Use of the product as directed
The power tool is designed for cutting, grinding and brushing metal or mineral materials (concrete, stone, etc.) without
use of water.
The working environment may be as follows: construction site, workshop, renovation, conversion or new construction.
Do not use the battery as a power source for other unspecified appliances.
Working with metals: Cutting, rough grinding, fine grinding, brushing
Working with mineral materials: Cutting, slitting using the corresponding guard (DC‑EX 125/5"-C), grinding using the
corresponding guard (DG‑EX 125/5").
Use only grinding discs, cutting discs and other accessories that are approved for use at a speed of at least 11000
/min for max. 125 mm diameter.
Use only synthetic resin-bonded, fiber-reinforced grinding or cutting discs or diamond cutting discs approved for use
at a peripheral speed of 80 m/sec.
The power tool may be used only for dry cutting or grinding.
Cutting or grinding materials containing asbestos is not permissible.
When grinding stone, a vacuum cleaner equipped with the appropriate filter, e.g. a suitable Hilti vacuum cleaner, must
be used.
Modification of the power tool or tampering with its parts is not permissible.
To avoid the risk of injury, use only genuine Hilti accessories and insert tools.
Observe the information printed in the operating instructions concerning operation, care and maintenance.
The power tool is designed for professional use and may be operated, serviced and maintained only by trained,
authorized personnel. This personnel must be informed of any special hazards that may be encountered. The power
tool and its ancillary equipment may present hazards when used incorrectly by untrained personnel or when used not
as directed.
18
Wear ear
hat protection
Volts
Revolutions
per minute
Location of identification data on the power tool
The type designation and serial number can be found
on the type identification plate on the machine or tool.
Make a note of this data in your operating instructions
and always refer to it when making an enquiry to your
Hilti representative or service department.
Wear
protective
Type:
gloves
Generation: 01
Serial no.:
Direct
current
Diameter