Description - Hilti DAG 500-D Manual De Instrucciones

Obligation signs
Wear eye Wear a hard
en
protection
Wear
breathing
protection
Symbols
Read the Return waste
operating material for
instructions recycling.
before use
Alternating Revolutions
current per minute
Rated speed

2. Description

2.1 Use of the product as directed
The power tool is designed for cutting, grinding and brushing metal or mineral materials (concrete, stone,
etc.) without use of water. Use of a guide carriage is mandatory for cutting stone.
The working environment may be as follows: construction site, workshop, renovation, conversion or new
construction.
The power tool may be operated only when connected to a power supply providing a voltage and frequency in
compliance with the information given on its type identification plate.
Working with metals: Cutting, rough grinding, fine grinding, brushing
Use only grinding discs, cutting discs and other accessories that are approved for use at a speed of at least
11000 r.p.m. at 5" diameter.
Use only synthetic resin-bonded, fiber-reinforced grinding or cutting discs or diamond cutting discs approved
for use at a peripheral speed of 80 m/sec.
The power tool may be used only for dry cutting or grinding.
2
Printed: 07.07.2013 | Doc-Nr: PUB / 5069466 / 000 / 00
Wear ear
hat protection
Volts
RPM
Revolutions per
minute
Diameter Double
insulated
Location of identification data on the power tool
The type designation, item number, year of man-
ufacture and technical status can be found on the
type identification plate on the machine or tool. The
serial no. can be found on the underside of the motor
Wear
housing. Make a note of this data in your operating
protective
instructions and always refer to it when making an
gloves
enquiry to your Hilti representative or service depart-
ment.
Type:
Serial no.:
Amps