Description - Hilti AG 125-A22 Manual De Instrucciones

under observation, well away from flammable ma-
terials, and allow it to cool down. Contact Hilti
Service after the battery has cooled down.
2.6.5 Work area safety
a) If the work involves breaking right through, take
the appropriate safety measures at the opposite
en

3 Description

3.1 Use of the product as directed
The power tool is designed for cutting and grinding metals and mineral materials.
Do not use the battery as a power source for other unspecified appliances.
Working with metals: Only with synthetic resin-bonded, fiber-reinforced grinding or cutting discs.
Working with mineral materials: Cutting and slitting using the corresponding guard (DC-EX 125/5"-C), grinding using
the corresponding guard (DG-EX 125/5").
The power tool may be used only for dry cutting or grinding.
It is recommended that a dust removal system consisting of matched components, i.e. dust removal hood and a
suitable Hilti vacuum cleaner, are used for working on mineral materials such as concrete or stone. These serve to
protect the operator and increase the life of the power tool and disc used.
Working on materials hazardous to the health (e.g. asbestos) is not permissible.
Observe the national health and safety requirements.
To avoid the risk of injury, use only genuine Hilti accessories and insert tools.
The power tool is designed for professional use and may be operated, serviced and maintained only by trained,
authorized personnel. This personnel must be informed of any special hazards that may be encountered. The power
tool and its ancillary equipment may present hazards when used incorrectly by untrained personnel or when used not
as directed.
3.2 Items supplied as standard include:
1 Power tool
1 Side handle
1 Standard guard
1 Front cover
1 Clamping flange
1 Clamping nut
1 Wrench
1 Operating instructions
NOTE
Approved accessories are available from your Hilti Center or can be ordered online at www.hilti.com.
3.3 Additional items required for operating the tool
A suitable battery of the specified type (see table in the Technical Data section) and a suitable battery charger from
the C 4⁄36 series.
3.4 Temperature-dependent motor protection
The temperature-dependent motor protection system prevents the power tool overheating by monitoring current input
and motor temperature.
In the event of motor overload due to application of excessive pressure to the disc, performance will drop noticeably
or the power tool may stop running (avoid stalling the power tool in this way).
If the power tool stalls or slows significantly due to overloading, release the pressure applied to the tool and then allow
it to run under no load for approx. 30 seconds.
20
side. Parts breaking away could fall out and / or fall
down and injure other persons.
b) Slits cut in loadbearing walls of buildings or other
structures may influence the statics of the structure,
especially when steel reinforcing bars or load-bearing
components are cut through. Consult the structural
engineer, architect, or person in charge of the
building project before beginning the work.