JANE MATRIX LIGHT 2 Manual Del Usuario página 29

Ocultar thumbs Ver también para MATRIX LIGHT 2:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 1
Ensure that the belt has not been caught between the folding seats
or doors.
It is only suitable for cars fitted with three anchoring point automatic
belts, approved according to Regulation ECE-16 or other equivalent rules.
WARNING: This Child Restraint System should not be used as a re-
clined cradle. It should only be used in vehicles and on pushchairs
that have been approved by Jané.
WARNING: Check the road traffic regulations in the country where
you are travelling. The use of your child restraint system may be
restricted.
RECOMMENDATIONS
Keep this instruction book for future reference. Always keep it in
the pocket inside the seat.
Ensure that inside the car, both luggage and any other object liable
to cause injury in the event of an accident are properly fastened
or stored.
The MATRIX LIGHT safety seat should be properly fixed with the
safety belts, even when not in use, as in the event of an accident
it may be thrown about, causing injury to the occupants of the
vehicle.
Remember not to use the MATRIX LIGHT safety seat in cars fitted
with a front airbag, unless it is disconnected or disabled, for which
you should consult the car manufacturer or retailer.
MAINTENANCE
Do not expose the cover to sunlight for long periods. When the
seat is not in use, cover it or store it in the boot.
Wash the plastic parts with warm water and soap, carefully drying
all the components afterwards.
The upholstery can be removed for washing. Follow the instruc-
tions below:
• Unfasten the safety harness clip and pass it through the slot in
the upholstery.
• Take off the rubber bands that go underneath the car seat belt
fasteners.
• And take off those that are on the base next to the handle.
• Take the upholstery off the MATRIX LIGHT safety seat.
• Undo the Velcro strips that are in the area of the seat belts and
pull the upholstery.
Wash by hand at a temperature never higher than 30° C.
To refit the cover, follow the same steps in reverse order.
For your safety and the good conservation of this product, it is
important to bring it to one of our official workshops for regular
inspections.
You can access the link: www.jane.es for further information
on fitting your new MATRIX LIGHT.
29

Publicidad

Tabla de contenido
loading

Tabla de contenido