Kenwood KDC-BT368U Manual De Instrucciones página 19

BLUETOOTH®
SETTINGS
AUTO ANSWER 1 to 30: The unit answers incoming call automatically in the selected time
(in seconds). ; OFF: Cancels.
BATT/SIGNAL* AUTO: Shows the strength of the battery and signal when the unit detects
a Bluetooth device and the Bluetooth device is connected. ; OFF: Cancels.
Clock time is shown.
* Functionality depends on the type of the phone used.
Make a call
You can make a call from the call history, phonebook, or dialing the
number. Call by voice is also possible if your mobile phone has the feature.
1
Press to enter Bluetooth mode.
"(First device name)" appears.
• If two Bluetooth phones are connected, press
another phone.
"(Second device name)" appears.
2
Turn the volume knob to select an item (see the following table), then
press the knob.
3 2
Repeat step until the desired item is selected/activated or follow
the instructions stated on the selected item.
4
Press and hold to exit.
To return to the previous setting item, press
CALL HISTORY (Applicable only if the phone supports PBAP)
1 Press the volume knob to select a name or a phone number.
• "INCOMING", "OUTGOING", or "MISSED" is shown on the lower part of
the display to indicate the previous call status.
• Press DISP to change the display category (NUMBER or NAME).
• "NO DATA" appears if there is no recorded call history.
2 Press the volume knob to call.
Default: XX
PHONE BOOK
again to switch to
NUMBER DIAL
.
VOICE
BATT LOW/MID/FULL * : Shows the strength of the battery.
NO SIGNAL/LOW/MID/MAX * : Shows the strength of the current received signal.
* Functionality depends on the type of the phone used.
(Applicable only if the phone supports PBAP)
1 Turn the volume knob quickly to enter alphabet search mode (if the
phonebook contains many contacts).
The first menu (ABCDEFGHIJK) appears.
• To go to the other menu (LMNOPQRSTUV or WXYZ1
J / K.
• To select the desired first letter, turn the volume knob or press
S / T, then press the knob.
Select "1" to search with numbers and select "
symbols.
2 Turn the volume knob to select a name, then press the knob.
3 Turn the volume knob to select a phone number, then press the
knob to call.
• The phonebook of the connected phone is automatically transferred
to the unit when pairing.
• Contacts are categorized as: HOME, OFFICE, MOBILE, OTHER, GENERAL
• This unit can display only non-accent letters. (Accent letters such as
"Ú" is showns as "U".)
1 Turn the volume knob to select a number (0 to 9) or character
( , #, +).
2 Press S / T to move the entry position.
1 2
Repeat steps and until you finish entering the phone number.
3 Press the volume knob to call.
(or using the remote control)
1 Press the number buttons (0 to 9) to enter the phone number.
2 Press
to call.
Speak the name of the contact you want to call or the voice command
to control the phone functions. ( 16, Make a call using voice
recognition)
* ), press
* " to search with
15
ENGLISH