Adjusting The Device - ABB M22341 Manual Del Usuario

ABB-Welcome
Pos : 70 /DinA4 - Anl eitungen Onli ne/Ueberschriften/2./Geraeteei nstellungen @ 18\mod_1302768847744_15.doc x @ 103548 @ 2 @ 1
4.5

Adjusting the device

Pos : 71 /DinA4 - Anl eitungen Onli ne/Ueberschriften/3./Absc hlus s widerstand @ 19\mod_1321958079906_15.doc x @ 110083 @ 3 @ 1
Pos : 72 /DinA4 - Anl eitungen Onli ne/Inhalt/KN X/D oor Entr y/Bedienung/Absc hl uss widerstand setzen 83220-AP- xxx @ 19\mod_1310723392369_15.doc x @ 107841 @ @ 1
Fig. 22:
Pos : 74 /DinA4 - Anl eitungen Onli ne/Inhalt/KN X/D oor Entr y/Bedienung/Master/Sl ave Schalter s etz en 83220-AP- xxx @ 19\mod_1310723320966_15.doc x @ 107833 @ @
1. Station
Selector switch to set the address of default outdoor station.
2. X10 X1
Selector switches to set the address (tens and units digits) of the indoor station.
X200 X100
Dip-switches to set the address (hundreds digits) of the indoor station.
3. Master /Slave function
Only one indoor station in each apartment must be set as "Master" (Switch should
be set as 'M/S on'). All additional indoor stations in the same apartment must be
set as "Slave" (Switch should be set as 'M/S off').
4. Terminal resistor
In video installations or mixed audio and video installations, the Switch must be
set as 'RC on' on the last device of the line.
5. a b = Bus connection
= Door bell connection
DC GND = Additional power supply
6. Connector for induction loop
Pos : 75 /Busc h-J aeg er (Neustr uktur)/Modul- Struktur /Online-Dokumentati on/Steuermodul e - Onli ne-D okumentation (--> F ü r all e D okumente <--)/++++++++++++ Seitenumbruc h ++++++++++++ @ 9\mod_1268898668093_0.doc x @ 52149 @ @ 1
|
— 30 —