Use; Cleaning; Decalcification - Profi Cook PC-WKS 1107 G Instrucciones De Servicio

Switching on / off
Switching on: Press the toggle switch downwards.
The indicator light in the switch lights up.
Switching off: Press the toggle switch upwards. The
indicator light in the switch goes off.

Use

NOTE:
Always use fresh water.
1. Place the appliance on a flat surface.
2. Press the button in the handle to open the kettle.
3. Then fill in the water (max. 1.5 Litre). You can read
the filling level on the water level indicator of the
kettle.
4. Close the lid. Press down on the contact area (2) to
close the lid.
5. Place the kettle flush on the base.
6. Only connect the appliance to a properly installed
safety socket.
7. Switch on the kettle by pressing the switch. The
control lamp in the switch will light up.
WARNING:
• Always turn the device off before cleaning it and remove the mains
plug. Wait until the device has cooled down.
• Never immerse the device or the base in water or other liquids.
CAUTION:
• Do not use any wire brush or other abrasive ob-
jects.
• Do not use any acidic or abrasive detergents
• Clean the perforated area of the spout from the in-
side with a nylon brush.
• Rinse the water container out with clean water.
Then dry it off with a cloth.
• Clean the housing after use with a slightly damp
cloth.
36
PC-WKS1107G_IM
Pausing / terminating operation
There are two options to interrupt the boiling process
or to terminate it:
1. The appliance will shut off automatically after the
boiling process. The indicator lamp will go out.
2. Push the rocker switch upwards to finish operation.
CAUTION:
Do not remove the appliance from the base without
shutting it off first
The contacts on the base are not suitable for discon-
necting the power supply.
WARNING: Danger of scalding!
• When pouring the water out, keep the lid closed.
• During operation the housing becomes hot. Do
not touch it and allow the device to cool down be-
fore storing it away.
• Disconnect the power cord.
• Emptying the water container.
Mains Cable Take-up Device
The mains cable can be wound up on the base.

Cleaning

• The frequency of the decalcifying operation de-
pends on the hardness of the water and on how
often the appliance is used.
• If the appliance switches off before the water boils,
it probably needs to be decalcified.
• Please do not use vinegar but a commercially avail-
able decalcification agent on the basis of citric acid.
Only use the quantities stated in the instructions.
NOTE:
After descaling the device boil fresh water in it
several times (approximately 3 - 4 times) in order to
remove any residues. Do not consume this water.

Decalcification

05.04.16