Velleman SOL30UC2 Manual Del Usuario página 4

4. Ove erview
Refer to the e drawings on page
1 charg e indicator
2 load i ndicator
3 LCD
4 Conne ections for solar pan
set-u up
a s solar panel
*
b b battery
5. Ins tallation
• Mount th he regulator in a coo
holes. U se M4x20 screws (n
• First con nnect a rechargeable
polarity! !
Note: u se multi-core insula
• Then co nnect a solar panel
solar pa nel is in accordance
polarity! !
• Finally c connect a DC device
sure the e connected load is i
switched d off. Use the correc
• When co onnecting an AC loa
(not incl l.) between battery
Do not short circuit o
thi s will lead to irrev
• To disco onnect the regulator
and fina lly the battery [b].
• Note tha at shorter connectio
6. Pro otection modes
• Over-dis scharge protection
voltage b becomes too low. Th
damage to the battery. Rem
is fully re echarged.
• Over-ch harge protection m
becomes s too high. The powe
damage to the battery until
• Over-loa ad protection mod
of more t than 30A.
• Load sh ort circuit protect
detected .
• Reverse e polarity protectio
not funct tion when reversed
the regul lator.
25/11/2010
SOL30UC2
2 of this manual.
nel
c
*
d
e
ol and ventilated, bu
not included) for eas
e battery [b] (not in
ated copper wire of a
[a] (not incl.) to co
e with the specificati
or appliance [d] (n
in accordance with t
ct polarity!
d [e] (not incl.), ins
[b] and load [e].
or reverse polarity
versible damage.
r, first disconnect th
n wires will reduce
s
n mode. This mode
he power to the outp
move the load from t
mode. This mode wil
er from the solar pa
the voltage drops b
de. This mode will be
tion mode. Enabled
on: in order to prev
connecting polarity
5 Connections for ba
6 Connections for D
7 control buttons
DC/AC c convertor*
*
DC load
*
AC load
ut dry location using
sy mounting.
ncl.) to connections
at least 6mm² and s
onnections [4]. Mak
ions of this regulato
not included) to con
the specifications of
stall a suitable DC-t
y of battery, solar
e solar panel [a], th
power losses.
will be enabled whe
put connectors is cu
the connector and w
l be enabled when t
nel input connector
below an acceptable
e enabled when the
when a short circui
vent possible damag
is detected. Correct
4
Rev. 0
attery
C load
* not included
g the 4 mounting
[5]. Use the correc
strip ±5mm.
ke sure the connecte
or. Use the correct
nections [6]. Make
f this regulator and
to-AC convertor [c]
r panel or load, as
hen the load [d or e
en the battery
ut off to prevent
wait until the battery
the battery voltage
is cut off to preven
level.
load draws a curren
t in the load is
ge the regulator will
t the polarity to use
©Velleman nv
01
ct
ed
s
e]
y
t
nt
e
v