Start Guide - Sharp AL-2061 Guía De Inicio

DIGITAL MULTIFUNCTIONAL SYSTEM

START GUIDE

This guide explains how to install the machine, and indicates important points to note for installation and usage. Read and understand this guide to ensure
that you install the machine correctly. The Operation Guide for the machine is on the accompanying CD-ROM. The procedure for viewing the guide is
explained in "How to use the operation guide". After installation, read the Operation Guide to make full use of all the machine has to offer.
1. CHECKING PACKED COMPONENTS AND
ACCESSORIES
Open the carton and check if the following components and accessories
are included.
If anything is missing or damaged, contact your authorized service
representative.
If the machine does not function properly during setup or use,
or if a function cannot be used, see "TROUBLESHOOTING
AND MAINTENANCE" (p.137).
START GUIDE
CD-ROM
TD cartridge
3. INSTALLING THE TD (TONER DEVELOPER) CARTRIDGE
Open the bypass tray, and
1
then open the side cover.
While pushing the lock
5
release button, gently
insert the TD cartridge
until it locks into place.
Lock release button
Power cord
Drum cartridge
(installed in unit)
Remove the CAUTION tape from the
2
front cover and remove the two
protective pins from the fusing unit by
pulling the strings upward one at a time.
Do not cut the strings.
CAUTION tape
Close the front cover and then the side cover by
6
pressing the round projections near the side cover
open button.
When closing the covers, be sure to close the
front cover securely and then close the side
cover. If the covers are closed in the wrong order,
the covers may be damaged.
2. PREPARING THE MACHINE FOR INSTALLATION
Be sure to hold the handles on both
1
sides of the machine to unpack the
machine and carry it to the installation
location.
Remove all pieces of tape shown in the illustration below and then open
2
the RSPF and remove the protective materials. Take out the bag
containing the TD cartridge.
Press gently on both sides
3
of the front cover to open
the cover.
Protective pins
Ensure that the power
7
switch of the unit is in the
OFF position. Insert the
attached power cord into
the power cord socket at
the rear of the unit.
MODEL: AL-2061
Remove the TD cartridge from
4
the bag. Hold the cartridge on
both sides and shake it
horizontally four or five times.
Hold the tab of the protective
cover and pull the tab to your
side to remove the cover.
4 or 5 times
Plug the other end of the
8
power cord into the
nearest outlet.
Only insert the power
cord into a properly
grounded wall socket.
Do not use extension
cords or power strips.
1