Roadstar TRA-886D+ Manual De Instrucciones página 5

TO USE THE RADIO
1. Press the [POWER] button (1) to power on;
2. (The first time you power on the radio, the radio will scan the DAB radio stations auto-
matically. It will display and play the first station after the scan is done);
3. Select the band (DAB or FM) by pressing the [MODE] button (2);
4. Adjust radio frequency to your desired station;
5. Adjust the volume with the [VOLUME KNOB] (3) to the desired level;
6. To power off the radio, press the [POWER] button (1).
Note: For a better reception reorient the antenna (10).
TUNE DAB STATION
To select the desired radio station press [TUNE] (4) and then:
1. Select desired radio station with the [TUNING KNOB] (3);
2. Press [ENTER] (3) to confirm.
Note: In case there is No DAB Service, press & hold the [MENU] button (7) and select "Full
Scan" to start scanning.
FM STATION SCAN
To select the desired radio station press [TUNE] (4) and then:
Use the [TUNING KNOB] (3) to fine tune the frequency in a step of 0.05 MHz.
•
Press [ENTER] button (3) to scan the previous/next available station.
•
PRESET
There are 10 presets available for DAB and 10 presets for FM.
1. Set the desired radio station frequency as explained previously;
2. Press and hold the [PRESET] button (9) and it will display "Save to P1";
3. Choose the number of preset by using the [TUNING KNOB] (3);
4. Press the [ENTER] button (3) and the display will show "Preset Stored".
RECALL A PRESET STATION
1. Press the [PRESET] button (9);
2. Select the desired preset by using the
3. Confirm with the [ENTER] button (3).
INFO
When the radio station is playing, press the [INFO] button (7) repeatedly to cycle through the
information broadcasted by the radio station.
NAVIGATE INTO THE MENU
1. Press and hold [MENU] (7) to access to the options;
2. Use the [TUNING KNOB] (3) to navigate into the options;
3. Press [ENTER] (3) to select the options;
4. Press [MENU] (7) to exit the menu.
CLOCK AND DATE SETTING
When the radio is ON:
1. Press and hold [MENU] (7) to access to the menu;
2. Use the [TUNING KNOB] (3) to select "System";
3. Confirm with the [ENTER] button (3);
4. Use the [TUNING KNOB] (3) to select "Time";
5. Confirm with the [ENTER] button (3);
6. Use the [TUNING KNOB] (3) to select "Set Time/Date";
English
[TUNING KNOB] (3);
2