Power Sources - Roadstar TRA-886D+ Manual De Instrucciones

1 English
LOCATION OF CONTROLS
1. POWER ON - OFF
2. MODE
3. VOLUME-TUNING KNOB / ENTER
4. TUNE
5. SLEEP TIMER
6. ALARM
7. MENU / INFO
8. DIMMER / SNOOZE
9. PRESET
10. ANTENNA
11. DC INPUT
12. EARPHONE OUT
13. BATTERY COMPARTMENT
PRECAUTION
INSTRUCTIONS - All the safety and operating instructions should be read before the
•
radio is operated. The manual should be retained for future reference.
HEED WARNINGS - All warnings on the appliance and in the operating instructions
•
should be adhered to.
WATER AND MOISTURE - The appliance should not be used near liquids or in rooms
•
with a high level of humidity.
VENTILATION - The appliance should be situated so that its location or position does
•
not interfere with its proper ventilation.
HEAT - The appliance should be situated away from heat sources such as radiators,
•
stoves or other appliances that produce heat.
POWER SOURCE - The radio should be connected to power supply only of the type
•
described in the operating instructions or as marked on the appliance.
POWER CORD PROTECTION - Power supply cords should be routed so that they are
•
not likely to be walked on or pinched by items placed upon/against them.
OBJECT AND LIQUID ENTRY - Care should be taken so that objects do not fall and
•
liquids are not spilled into the enclosure through openings.
SERVICING - The user should not attempt to service the appliance beyond that descri-
•
ve in the user operating instructions. All the servicing should be referred to qualified
service personnel
Note: If the display does not function properly or no reaction to operation of any control may
due to the electrostatic discharge. Switch off and disconnect the power cord and remove all
the batteries, then turn the power back on after a few seconds.

POWER SOURCES

AC POWER: You can power your portable stereo system by plugging the AC/DC adaptor
into the DC plug (11) at the back of the unit and into a wall AC power outlet.
Check that the rated voltage of your appliance matches your local voltage.
BATTERY POWER: To use the radio with batteries, disconnect the AC/DC adaptor and in-
sert 4 × "LR6" batteries into the compartment (13).
Be sure that the batteries are inserted correctly to avoid damage to the appliance.
Remove the batteries when the radio will not be used for a long period of time, as this will
cause leakage to the batteries and subsequently damage to your radio.