Stihl 4853 Serie Manual De Instrucciones página 32

English
To reduce the risk of accidents, take a
break in good time to avoid tiredness or
exhaustion.
Never work with the
power tool in the rain or in
wet or very damp
locations.
Static electricity may build-up while
blow-sweeping large quantities of very
dusty material and suddenly discharge
in certain unfavorable conditions (e.g.
very dry work area).
If dust levels are very high, always wear
a suitable respirator.
Never attempt to insert objects into the
impeller housing through the intake
screen or the nozzle. They may be
expelled at very high speed by the
impeller – risk of injury.
If there is a noticeable change in running
behavior (e.g. higher vibrations), stop
work and rectify the cause of the
problem.
If your power tool is subjected to
unusually high loads for which it was not
designed (e.g. heavy impact or a fall),
always check that it is in good condition
before continuing work – see also
"Before Starting Work". Make sure the
safety devices are working properly. Do
not continue operating your power tool if
it is damaged. In case of doubt, have the
unit checked by your servicing dealer.
Before leaving the power tool
unattended: Always switch off the power
tool, set the retaining latch to ƒ and
remove the battery.
30
After finishing work
Always clean dust and dirt off the power
tool – do not use any grease solvents for
this purpose.
Vibrations
This power tool is minimizes the
vibrations transmitted to the operator's
hands.
However, the operator should seek
medical advice in the event of suspected
circulatory problems in the hands (e.g.
tingling sensation in the fingers).
Maintenance and Repairs
Always move the retaining latch to ƒ
and remove the battery before carrying
out any repairs or maintenance work on
the power tool. This avoids the risk of
the motor starting unintentionally.
Service the machine regularly. Do not
attempt any maintenance or repair work
not described in the instruction manual.
Have all other work performed by a
servicing dealer.
STIHL recommends that you have
servicing and repair work carried out
exclusively by an authorized STIHL
servicing dealer. STIHL dealers are
regularly given the opportunity to attend
training courses and are supplied with
the necessary technical information.
Only use high-quality replacement parts
in order to avoid the risk of accidents
and damage to the machine. If you have
any questions in this respect, consult a
servicing dealer.
STIHL recommends the use of genuine
STIHL replacement parts. They are
specifically designed to match your
model and meet your performance
requirements.
Never attempt to modify your power tool
in any way since this will increase the
risk of personal injury.
Regularly check the electrical contacts
and ensure that the insulation of the
connecting cord and plug of the charger
is in good condition and show no sign of
ageing (brittleness).
Electrical components, e.g. connecting
cord of charger, may only be repaired or
replaced by a qualified electrician.
Clean plastic components with a cloth.
Do not use aggressive detergents. They
may damage the plastic.
Carefully clean the intake screen in the
impeller housing with a soft brush
whenever required.
Keep the battery guides free from
foreign matter – clean as necessary.
Store the power tool in a dry, locked
location with the retaining latch on ƒ
and the battery removed.
BGA 85