Stihl BT 130 Manual De Instrucciones página 7

augers are useable with STIHL power
tools, their use may, in fact, be
extremely dangerous.
If this tool is subjected to unusually high
loads for which it was not designed (e.g.
heavy impact or a fall), always check
that it is in good condition before
continuing work. Check in particular that
the fuel system is tight (no leaks) and
that the controls and safety devices are
working properly. Do not continue
operating this machine if it is damaged.
In case of doubt, have it checked by your
STIHL servicing dealer.
THE USE OF THE POWER TOOL
Transporting the Power Tool
WARNING
Always stop the engine before putting
the earth auger down or carrying it.
Carrying an earth auger with the engine
running is dangerous. Accidental
acceleration of the engine can cause the
drilling tool to rotate.
WARNING
During operation, the powerhead muffler
and the parts around it reach extremely
high temperatures. Avoid setting down a
hot unit onto dry, flammable material, or
touching the hot muffler; you could
receive serious burns.
Carry the unit by the handle frame with
hot parts of the machine (e.g., gearbox)
away from your body.
Remove the auger before transporting
the power tool long distances.
BT 130
When transporting in a vehicle, properly
secure your power tool to prevent
turnover, fuel spillage and damage.
When the power tool is not in use, shut it
off and put it down so it cannot endanger
others.
Fuel
Your STIHL power tool uses an oil-
gasoline mixture for fuel (see the
chapter on "Fuel" of your instruction
manual).
WARNING
Gasoline is an extremely
flammable fuel. If spilled
and ignited by a spark or
other ignition source, it
can cause fire and seri -
ous burn injury or
property damage. Use
extreme caution when
handling gasoline or fuel
mix. Do not smoke or
bring any fire or flame
near the fuel or the power
tool. Note that combusti -
ble fuel vapor may
escape from the fuel
system.
Fueling Instructions
WARNING
Fuel your power tool in well-ventilated
areas, outdoors. Always shut off the
engine and allow it to cool before
refueling. Gasoline vapor pressure may
build up inside the fuel tank depending
on the fuel used, the weather conditions
and the tank venting system.
In order to reduce the risk of burns and
other personal injury from escaping gas
vapor and fumes, remove the fuel filler
cap on your power tool carefully so as to
allow any pressure build-up in the tank
to release slowly. Never remove the fuel
filler cap while the engine is running.
Select bare ground for fueling and move
at least 10 feet (3 m) from the fueling
spot before starting the engine. Wipe off
any spilled fuel before starting your
machine.
WARNING
Check for fuel leakage
while refueling and during
operation. If fuel leakage
is found, do not start or
run the engine until the
leak is fixed and any
spilled fuel has been
wiped away. Take care
not to get fuel on your
clothing. If this happens,
change your clothing
immediately.
Screw Cap
WARNING
Unit vibrations can cause
an improperly tightened
fuel filler cap to loosen or
come off and spill quanti -
ties of fuel. In order to
reduce the risk of fuel
spillage and fire, tighten
the fuel filler cap by hand
as securely as possible.
See "Fueling" chapter in your instruction
manual.
English
5