Cebora PROF162 Manual De Instrucciones página 8

2.2 DESCRIPTION OF THE EQUIPMENT (FIG. 2)
A) Function switch 0-1.
B) Mains power lamp.
C) Fixed torch fitting.
D) Torch fitting guard.
E) Grounding cable socket.
F) Mobile fitting.
G) Pressure gauge.
H) Knob to adjust the gas pressure.
I) Gas supply fitting (1/4" female gas threading).
J) Water trap.
K) Power cord.
L) Interface connector. (Upon request).
N) 230V socket to power the cooling unit.
O) Fuse (5A-250V-T).
P) Cooling unit connector.
Q) Cooling unit fastening points.
8
R)
S)
T)
U)
V)
W)
X)
Y)
Z)
AA)
AB)
fig. 1
AC)
AD)
2.3
N°.
type
TORCH TYPE Type of torch that may be used with this
U0.
X.
at
I2.
U2.
U1.
fig. 2
Max. distance between the power source and
cutting point.
Gas intake pressure.
LED. Indicate the type of torch connected.
LED. Indicates that connection art. 1194 or art.
1194.10 is connected, plus the unit HV-16 art.
482, plus the torch CP200 art. 1235.
LED. Indicates that there is voltage at socket N.
LED. Indicates that the cooling unit is off, the
water circuit pressure is too low, or that the con-
nector P is not connected properly.
Display. Indicates the cutting current or error
codes. (see par. 6).
Display. Indicates the recommended nozzle hole
diameter (not valid for a ø3 deseaming nozzle).
Knob to adjust the cutting current.
LED. Indicates that the gas pressure is too low.
LED. Indicates that the thermostat is tripped.
LED. Indicates that the machine is blocked for
safety reasons.
LED. Indicates that the electrode has run out.
EXPLANATION OF THE TECHNICAL SPECIFI-
CATIONS LISTED ON THE MACHINE PLATE.
Serial number; must be indicated on any
of request regarding the welding machine.
Downslope.
Suitable for plasma cutting.
machine.
Secondary open-circuit voltage (peak value)
Duty cycle percentage.
Expresses the percentage of 10 minutes
during which the welding machine may run
a certain current without overheating.
Cutting current
Secondary voltage with welding current I2
Rated supply voltage