Customizing Your Monitor; Using The Geometry; On-Screen Display - IBM P96 Manual De Instrucciones

Customizing Your Monitor

Using the GEOMETRY

screen Display
The GEOMETRY settings allow you to adjust the shape and
orientation of the picture.
Once the (Rotation) is adjusted, it will be stored in
memory for all input signals received. All other adjustments
will be stored in memory for the current input signal.
1
Press the button.
The MENU OSD appears.
2
Press the ./> buttons to select "
press the button again.
The GEOMETRY OSD appears.
3
Press the ./> buttons to select the item you want
to adjust.
Select To
(Rotation) adjust the picture rotation
(Pincushion) adjust the picture sides
(Pin Balance) adjust the picture side balance
(Keystone) adjust the picture width
(Key Balance) adjust the picture shape balance
8
On-
GEOMETRY" and
GEOMETRY
2 6
4
Press the ?// buttons to adjust the settings.
For Press
(Rotation) / . . . to rotate the picture clockwise
? . . . to rotate the picture counterclockwise
(Pincushion) / . . . to expand the picture sides
? . . . to contract the picture sides
(Pin Balance) / . . . to expand the picture sides to the
? . . . to expand the picture sides to the left
/ . . . to increase the picture width at the
(Keystone)
? . . . to decrease the picture width at the
/ . . . to move the top of the picture to
(Key Balance)
? . . . to move the top of the picture to
Press the button once to return to the MENU OSD, and
twice to return to normal viewing. If no buttons are pressed,
the OSD closes automatically after about 30 seconds.
To reset, press the ? (reset) button while the OSD is on.
The selected item is reset to the factory setting.
right
top
top
the right
the left