Locking The Controls; Restoring The Color - IBM P96 Manual De Instrucciones

Locking the controls

You can protect adjustment data by locking the controls.
1
Press the button.
The MENU OSD appears.
2
Press the ./> buttons to select "
press the button again.
The OPTION OSD appears.
3
Press the ./> buttons to select "
LOCK)."
4
Press the / button to select "ON."
Press the button once to return to the MENU OSD, and
twice to return to normal viewing. If no buttons are pressed,
the OSD closes automatically after about 30 seconds.
Only the u (power) switch, EXIT, and "
LOCK)" of the " OPTION" OSD will operate. If any other
items are selected, the mark appears on the screen.
To cancel the control lock
Repeat steps 1 through 3 above and press the ? button to
select "OFF."

Restoring the color

The colors of most display monitors tend to gradually lose
brilliance over several years of service. The IMAGE
RESTORATION feature allows you to restore the color to
the original factory quality levels.
1
OPTION" and
2
OPT I ON
DEGAUSS
ON
(CONTROL
OPT I ON
3
CONTROL
LOCK
OF F ON
4
The picture disappears while the color is being restored
(CONTROL
(about 2 seconds). After the color is restored, the picture
reappears on the screen again.
Press the
twice to return to normal viewing. If no buttons are pressed,
the OSD closes automatically after about 30 seconds.
Getting Started Customizing Your Monitor
Customizing Your Monitor
Press the button.
The MENU OSD appears.
Press the ./> buttons to select "
press the button again.
The OPTION OSD appears.
Press the ./> buttons to select "
RESTORATION)."
Press the / button to select "ON."
button once to return to the MENU OSD, and
OPTION" and
OPT I ON
DEGAUSS
ON
EN
F
(IMAGE
ES
OPT I ON
C
ON
COLOR
RE T URN
13