Description; Purpose; Overview; Safety - GreenWorks G40LM35 Manual Del Operario

Ocultar thumbs Ver también para G40LM35:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 15
EN
1

DESCRIPTION

1.1

PURPOSE

This machine is used for domestic lawn mowing. The cutting
blade must be approximately parallel to the ground. All four
wheels must touch the ground while you mow.
1.2

OVERVIEW

Figure 1-9.
Quick-release lever
1
Lower handle
2
Upper handle
3
Knob
4
Bolt
5
Grass catcher
6
Rear discharge door
7
Mulch plug
8
Height adjustment lever
9
Battery door
10
Battery pack
11
Safety key
12
Start button
13
Handle switch
14
Front wheel
15
Rear wheel
16
Slot
17
Mounting nut
18
Spacer
19
Blade
20
2

SAFETY

Make sure that you do/obey all safety instructions.
Refer to Safety Manual.
3

INSTALLATION

Do not change or make accessories that are not
recommended by the manufacturer.
Do not put in the safety key or the battery pack until you
assemble all the parts.
WARNING
WARNING
WARNING
English
3.1

UNPACK THE MACHINE

Make sure that you correctly assemble the machine before
use.
If the parts are damaged, do not use the machine.
If you do not have all the parts, do not operate the
machine.
If the parts are damaged or missing, speak to the service
center.
1. Open the package.
2. Read the documentation in the box.
3. Remove all the unassembled parts from the box.
4. Remove the machine from the box.
5. Discard the box and package in compliance with local
regulations.
3.2
UNFOLD AND ADJUST THE
LOWER HANDLE
Figure 2.
1. Pull up and back the upper handle to lift the handle into
operation position. Make sure that the handles click into
position correctly.
2. Tighten the lower handle with the quick-release levers on
the two sides.
Make sure that the two handles are in the same position.
Do not make damage to the cables when you fold or unfold
the handle.
3.3

INSTALL THE UPPER HANDLE

Figure 3.
1. Align the holes in the upper handle and the lower handle.
2. Put the bolts through the holes.
3. Tighten the knobs onto the bolts.
4. Do the same operation on the other side.
3.4

INSTALL THE GRASS CATCHER

Figure 4.
1. Remove the mulch plug.
2. Open the rear discharge door and hold it.
3. Hold the the grass catcher by its handle and put the hooks
over the slots.
4
WARNING
WARNING
NOTE
WARNING

Publicidad

Tabla de contenido
loading

Tabla de contenido