1.
ensure the battery clips are securely clipped on the storage holders.
2.
Open the protective cover of the DC power outlet on the front of the Instant Power™.
3.
Plug the 12V DC device into the DC power outlet, and turn the 12V DC device on (if
required) NOTE: the flex light ON/OFF control is on the back of the light.
4.
If the 12V DC device draws more than 15A or has a short circuit, the internal circuit
breaker of the Instant Power™ will trip and disconnect the power to the device. If this
occurs, disconnect the 12V DC device in question and press the reset button located
on the back of the Instant Power™ to reset the circuit breaker.
The DC power outlet is wired directly to the internal battery. Extended operation of a 12V
DC device may result in excessive battery drain. Recharge immediately after unplugging
the 12V DC device.
Appliance Type
Cell Phone
Fluorescent Light
Radios, Fan
Depth Finder
Camcorder, VCR
electrical Tool
electrical Cooler
Car Vacuum, Air Compressor
NOTE: estimated run-times. Actual time may vary. Times are based on the internal
battery being fully charged
10.3
Flex Light Light Bulb Replacement
The bulb used in the IP-1850FL light is a 12 volt, 5 watt halogen bayonet type.
1.
Disconnect the Flex Light from the Instant Power™.
2.
To replace the bulb, unscrew the cover on the lamp back, remove the old bulb, then
replace with a new 12 volt, 5 watt halogen bulb.
3.
Finally screw the cover onto the lamp housing.
10.4
Using the Built-In Light
1.
Position the Instant Power™ on a flat, stable surface near the intended work area.
2.
ensure the battery clips are securely clipped on the storage holders.
3.
Press the Battery Status switch to turn on the light.
4.
The Instant Power™ light will turn on and illuminate your work area.
5.
Press the Battery Status switch when the work is completed to turn off the light.
6.
Charge the Instant Power™ as soon as possible after using the work light.
11.
MAINTENANCE INSTRUCTIONS
11.1
After use and before performing maintenance, unplug and disconnect the Instant
Power™ (see sections 3 and 4).
11.2
Use a dry cloth to wipe all battery corrosion and other dirt or oil from the battery clips,
cords, and the Instant Power™ case.
11.3
ensure that all of the Instant Power™ components are in place and in good working
condition, for example, the plastic boots on the battery clips.
11.4
Servicing does not require opening the unit, as there are no user-serviceable parts.
11.5
All other servicing should be performed by qualified service personal.
12.
MOVING AND STORAGE INSTRUCTIONS
12.1
Store the Instant Power™ in an upright position.
12.2
Store inside, in a cool, dry place.
Estimated Wattage
4 watts
4 watts
9 watts
9 watts
15 watts
24 watts
48 watts
80 watts
• 6 •
Estimated Usage Time
54 hours
54 hours
24 hours
24 hours
14.4 hours
9 hours
4.5 hours
2.7 hours