•
Adjust the desired inclination angle via the mounting bracket and tighten the bracket screws.
•
Always secure the installation with a secondary attachment e.g. a safety cable.
•
Never stand directly below the device when it is being mounted, removed or serviced. Have a
qualified technician check the device once a year and once before you bring it into service.
•
Install the device in a location with few passers-by that is inaccessible to unauthorised persons.
•
Overhead mounting requires extensive experience: calculating workload limits, determining the
installation material to be used... Have the material and the device itself checked regularly. Do not
attempt to install the device yourself if you lack these qualifications as improper installation may
result in injuries.
•
For truss mounting, use an appropriate clamp (not incl.) and fit an M10 bolt through the centre of the
(folded) bracket.
•
Adjust the desired inclination angle via the mounting bracket and tighten the bracket screws.
•
Make sure there is no flammable material within a 0.5 m radius of the device.
•
Have a qualified electrician carry out the electric connection.
•
Connect the device to the mains with the power plug. Power all devices directly off a grounded
switched circuit and do not run off a rheostat or dimmer circuit, even when using the rheostat or
dimmer channel solely for 0 % to 100 % switching.
•
An expert must approve the installation before taking the device into service.
DMX-512 Connection
•
When applicable, connect an XLR cable to the female XLR output of a controller (not incl.) and the
other side to the male XLR input [4] of the device. Multiple devices can be linked through serial
linking. The linking cable shall be a dual core, screened cable with XLR input and output connectors.
•
Use a DMX signal amplifier when the signal cable distance exceeds 60 meters (200 ft). Maximum
recommended number of devices on a serial data link is 32 devices.
•
A DMX terminator is recommended for installations where the DMX cable has to run a long distance
or is in an electrically noisy environment (e.g. discos). The terminator prevents corruption of the
digital control signal by electrical noise. The DMX terminator is simply an XLR plug with a 120 Ω
resistor between pins 2 and 3, which is then plugged into the XLR output socket [5] of the last
device in the chain.
7.
Operation
The device can be used in the following modes:
•
built-in programmes (stand-alone or master/slave)
•
sound activation (stand-alone or master/slave)
•
RGBW mode (stand-alone with fixed colour(s))
•
DMX (stand-alone or master/slave).
7.1
Control Panel Navigation
The control buttons [6] are located at both sides of the display [7].
Button
Function
MENU
to access the menu, quit the current function without saving the setting, or quit the menu
UP
to scroll upward in a list of functions or options, or increase a value
DOWN
to scroll downward in a list of functions or options, or decrease a value
ENTER
to confirm and save a selected option or value
menu item
Addr
Chnd
Slnd
V. 02 – 04/09/2014
VDPLP608RGBW
function
001-512
5CH
9CH
Nast
Sl1
Sl2
description
DMX address setting
5-channel mode
9-channel mode
master mode
slave mode – normal
slave mode – light show
5
©Velleman nv