Memory Recall - Bosch DUS 20 plus Instrucciones De Servicio

EURO • Printed in Germany • BA 1 609 929 C10 • DUS 20 plus • GB • OSW
09/00
DUS 20 - Bildseite.book Seite 5 Donnerstag, 5. Oktober 2000 11:27 11
Memorizing the Measured Value,
"Add to" Function
By pushing the (M+) "Add to memory" push button 6, the
value on the bottom right side of the display – depending on
the current measuring operation a length-, surface- or volu-
metric value – is memorized and an "M" appears on the bot-
tom left side of the display. If another value has already
been memorized, the new value is added to the contents of
the memory, however only if the units of measurement cor-
relate. For example: If a square value is in the memory and
the current measured value is volumetric, the addition can
not be carried out. In this case "ERROR" will blink on the up-
per right of the display.

Memory Recall

By pressing the (MR) "Memory recall" push button 5, the
memorized contents can be checked on the display at any
time for a duration of three seconds. When doing so, the
memory symbol "M" blinks together with the length-, sur-
face- or volumetric symbol, depending on the type of meas-
ured value in the memory. Afterwards the display automat-
ically switches back to the current measuring value.
The memorized value remains memorized even when the
unit is switched off.
Clearing Measured Values (C/MC)
Repeated pressing of the (C/MC) "Clearing" push button 7,
clears in succession:
m
M
2
m
m
M
m
M
m
If only the memorized value "M" is to be cleared, press the
(MR) "Memory recall" push button, which will indicate the
value on the display, and then clear the indicated value by
pressing the (C/MC) "Clearing" push
button 7.
1 609 929 C10 • TMS • 25.09.00
the last measured value,
all measured values,
the memorized value, in case
the "M" symbol is indicated on
the display 4.
English - 5