Cleaning And Servicing - Starmix XT 1000 E Instrucciones De Montaje Y De Uso

• Fix the installation pattern on the wall at the height recommended in the table shown below on the left.
• Mark the centre of the four fi xing holes to be drilled with a sharp-pointed instrument, then drill the holes using an 8 mm drill bit.
• Remove the lid from the appliance; to do this, unscrew completely both the anti-theft screws on the mounting plate. Use the special
hexagon spanner supplied to do this.
• Next, fi x the mounting plate to the wall, using the wall plugs and screws supplied.
• Connect the appliance to the power supply, taking care to observe the information in the chapter entitled "Safety instructions". THIS
MAY ONLY BE CARRIED OUT BY A QUALIFIED ELECTRICIAN
• Place the cover on the appliance again, and fi x it with the two anti-theft screws. Tighten the screws by hand.

7 Cleaning and servicing

Clean the air inlet openings to remove sticking fl uff and dust as required with a narrow vacuum cleaner fi tting. Remove any dirt which is still
stuck in the air inlet with a stiff brush. The surface of the housing may be wiped over with a damp or a dry cloth. Abrasive cleaners must not
be used.
8 Note
Old equipment contains valuable materials which are designed for re-processing. The vacuum cleaners must not be
thrown away in the normal household waste, but should be disposed of at a suitable proper collection system, e. g.
via your communal disposal location.
GB - 15