wolfcraft 6134 Manual Del Usuario página 4

Assembly
Assembling the Workbench
Note: For correct assembly, the legs, [A] and [B],
must have hinges on the outside.
Refer to Figure 2 for steps 1 - 3
1. Attach the front cross bar [J] to the leg assem-
blies [A & B] with two screws, [D] (M6 x 45),
medium washers [E] and nuts [F] (M6) on each
side. Tighten securely.
2. Attach the tool storage rack [G] to the leg
assemblies [A & B] with a screw [H] (M6 x 12),
two small washers [I], and nut [F] (M6) on each
side. Tighten securely.
3. Attach the rear cross bar [J] to the leg
assemblies. Use two screws [D] (M6 x 45),
medium washers [E], and nuts [F] (M6) on each
side. Tighten securely.
Refer to Figure 3 for steps 4 - 8
4. Place the two top supports [L] on the front and top
of the leg assemblies [A & B] with the support's
round knobs facing up and away from the front of
the table. The bottom round holes fit over the
threaded knobs of each screw arm assembly.
Figure 2
A
H
I
G
H
I
D
J
D
D
B
I
I
F
I
F
I
E
F
F
E
K
5. Place the front table top [M] on the supports [L],
aligning the table top holes over the round
support knobs and press into place.
6. Push on the threaded plastic traverse under
the channel and attach top using two screws
[N] (M8 x 55) and two large washers [O].
Tighten securely.
7. Place two table top supports [L] on rear and top
of the leg assemblies [A & B] with the round
knobs of the supports facing up and toward the
front of the table. The supports fit into the
rectangular cut-outs in the leg assemblies.
8. Place the rear table top [P] on the supports [L],
aligning the table top holes over the support
knobs and press into place. Install two screws [N]
(M8 x 55) and two large washers [O] in table top.
Move top and supports to the rear-most position
and install two large washers [O] and two nuts [Q]
(M8) in table bottom. Place the assembly in
position and tighten securely.
Figure 3
J
D
E
E
K
WOLF112-2
4
N
O
N
O
L
L
O
Q