Arcora ANIKO 30 FOAMTEC Manual De Uso Y Mantenimiento página 13

ANIKO 30 FOAMTEC is a machine spraying on the surfaces to be cleaned a special foam,
obtained by mixing compressed air with a special detergent. In a second step, the foam and
the dirt are removed by rinsing the surfaces with clean water. Then, with the same machine,
it is also possible to vacuum the residual liquid from hard floor.
ANIKO 30 FOAM has been designed for cleaning and sanitizing panes, fixtures and other
surfaces in restrooms and showers, in areas open to public, such as train stations, airports,
swimming pools, fitness centres, saunas, locals, hospitals, hotels and so on. ANIKO 30
FOAM can be used in any other place where the system foam + rinse + vacuum is
convenient.
Every electrical device must be used for its particular function only, respecting the manufacturer's
instructions. Failure to adhere to the instructions could result in serious person injury, electric shock,
fire or explosion.
The nowadays machines are normally produced according to the accident prevention regulations and
are often homologated by qualified institutes for the safety, but nobody and nothing can save
irresponsible users from danger.
Please, read carefully the following points and be sure to understand everything before using the
machines. The following information signals potentially dangerous conditions to the operator or
equipment.
WARNING: Fire or Explosion Hazard.

Do not spray water near electrical outlets.

Do not use the machine to spray or to suck dust, corrosive liquids (acids or bases) and explosive
or inflammable liquids.

Do not use the machine in an explosive atmosphere. This machine is not equipped with an
explosion proof motor. The electric motor will spark when powered on which could cause a flash
fire or explosion if machine is used in an area where flammable vapors/liquids or combustible
dusts are present.

Never use flammable liquids or operate machine in or near flammable liquids, vapors or
combustible dusts.
WARNING: Electrical Hazard.

Before putting the machine's plug in the current socket, check that the voltage available is the
same indicated on the label of the machines.

Be sure that the electrical system is well earthed and that it has a safety differential switch.
Generalities
Safety instructions (read carefully)
13