Installation - Sharp R-208-AA Manual De Instrucciones Y Recetario

To promote trouble-free use of your oven and
avoid damage.
Never operate the oven when it is empty.
When using a browning dish or self-heating material,
always place a heat-resistant insulator such as
a porcelain plate under it to prevent damage to the
turntable and roller stay due to heat stress. The preheating
time specified in the dishes instructions must not be
exceeded.
Do not use metal utensils, which reflect microwaves and
may cause electrical arcing. Do not put cans in the oven.
Use only the turntable and the roller stay designed for this
oven. Do not operate the oven without the turntable.
To prevent the turntable from breaking:
(a) Before cleaning the turntable with water, leave the
turntable to cool.
1. Remove all packing materials from the inside of
the oven cavity. Discard the loose polythene sheet
from between the door and cavity. Remove the
feature sticker, if attached, from the outside of
the door.
Do not remove the protective film attached to the
inside of the door.
✓
REMOVE
ENERGY SAVE MODE:
Your oven comes pre-set for Energy Save Mode.
This facility saves electricity when the oven is not in use.
When you first plug it in, you cannot operate the oven until you open and close the oven door.
In Energy Save Mode, if you do not operate the oven for 3 minutes or more (i.e. closing the door or at the end
of cooking), you will not be able to operate the oven until you open and close the oven door.
R-208-AA [01 EN].pdf 3
IMPORTANT SAFETY INSTRUCTIONS
✗
DO NOT REMOVE
106
(b) Do not put hot foods or hot utensils on a cold turntable.
(c) Do not put cold foods or cold utensils on a hot turntable.
Do not place anything on the outer cabinet during
operation.
NOTE:
If you are unsure how to connect your oven, please consult
an authorised, qualified electrician.
Neither the manufacturer nor the dealer can accept any
liability for damage to the oven or personal injury resulting
from failure to observe the correct electrical connection
procedure.
Water vapour or drops may occasionally form on the oven
walls or around the door seals and sealing surfaces. This is
a normal occurrence and is not an indication of microwave
leakage or a malfunction.

INSTALLATION

2. Check the oven carefully for any signs of
damage.
3. Place the oven on a flat, level surface strong
enough to support the oven's weight plus the
heaviest item likely to be cooked. Do not place
the oven in a cabinet.
4. Ensure there is a minimum free space above the
oven of 15cm:
5. Securely connect the plug of the oven to a
standard earthed (grounded) household electrical
outlet.
8/22/09 2:37:33 PM
15cm