Warnings; Useful Warnings - ELICA SUM1 Guía De Instalación, Uso Y Mantenimiento

Warnings!

The air outlet of the appliance must not be connected to a flue which is used for
exhausting
other fumes from appliances, such as a central heating, boilers etc..
For the external exhausting of the fumes, comply with the regulations in force.
Ventilate the room suitably according to the laws in force when the appliance is
wor­king together with gas, oil or coal burning appliances, at the same time.
The motor of the peripheral exhausting group is powered by the cooker hood placed in the
kitchen.
Before connecting the cooker hood to the mains supply, make sure that the voltage
indicated in the rating plate corresponds to the mains voltage in the home.
Before carrying out any sort of maintenance or cleaning operation, make sure that the
appliance is disconnected from the electrical mains.
An appropriate maintenance ensures a good working and a good performance in the long
run.

Useful warnings:

Use an air outlet pipe with a maximum length not higher than 5 meters.
Limit the number
per­formance up to one linear meter. (If you use 2 90° bends, than the length of the
pipe has not to be higher than 3 meters).
The material for the pipe has to be approved by an authorized company.
It is important to avoid changes in the diameter (we recommend a diameter of 150mm).
Read carefully the manual of instructions and installation of the unit.
Elica will not be responsible for problems of capacity and/ or noise level due to the
missed respect of the warnings included in the manual of instructions.
SEM6 are equipped with a 200mm diameter hole for the exhausting pipe. If the unit that
has to be connected to the remote fan is already equipped with a 200mm diameter hole,
the nit is recommended to use a pipe with the same diameter in order to get good
performances. Otherwise, if the unit is equipped with a 150mm diame­ter hole, than it is
recommended to use the joint (from 200mm to 150mm), already supplied with the unit.
The electric box cable should not be cut or joined together with other cables, since it
could compromise
Furthermore, this will invalidate the manufacturer's warranty coverage.
Warnings!
The SEM6 suction
manufacturer if they are equipped with the External Motor version.
The manufacturer cannot be held responsible for damages caused by a different use.
6
of bends in
the proper working
centrals can be
the exhausting pipe
and the safety
connected to any
as every bend
conditions of the
other products from
reduces the
appliance.
the same