Beem Multi-FiXX 500 Manual De Instrucciones página 25

EN
Mixing
(see images A1 - A6)
Place the sealing ring (14) around the
‹
base of the chopping unit (13). Make
sure that the sealing ring is lying flat
all the way round.
Insert the blade unit (13) with the fit-
‹
ted sealing ring (14) into the blender
jug (15) from below. The noses of the
base fit into the recesses at the bot-
tom of the blender jug.
Turn the blade unit (13) with the lid
‹
lock (17) anticlockwise to tighten.
Place the blender jug (15) onto the
‹
motor unit (1) with the handle to the
right and turn the blender jug clock-
wise until it audibly snaps in.
NOTE
► Make sure that the blender jug (15)
is seated properly, otherwise the ap-
pliance cannot be operated (safety
switch).
Put liquid/fruit into the blender (15).
‹
NOTE
► Pour liquids into the blender first and
then the solids.
► Do not put solid parts (metal, wood,
bones) into the blender jug.
► Cut through larger parts so that the
blade unit (13) can seize them.
► Pay attention to the maximum filling
quantity in the blender jug (15).
BEEM - Elements of Lifestyle
Place the lid of the blender (16) onto
‹
the blender jug (15) and lock it by
turning it clockwise.
Place the lid lock (17) onto the lid of
‹
the blender (16) and lock it by turning
it clockwise until it snaps in.
NOTE
► Pay attention to proper seating of the
lid (16) and the lid lock (17) to pre-
vent squirting out of the appliance.
Insert the plug into the mains socket
‹
and move the rotary switch (2) to im-
pulse or continuous operation.
CAUTION
► Observe the maximum operating
time of 2 minutes.
► Allow the appliance to cool down for
1 minute.
Refilling:
Switch off the appliance.
‹
Remove the lid lock(17) and fill the
‹
blender (15).
Close the lid (16) again with the lid
‹
lock (17).
NOTE
► Pay attention to the maximum filling
quantity in the blender jug (15).
Multi-FiXX 500
23