Beem Multi-FiXX 500 Manual De Instrucciones página 27

EN
Cutting/rasping
(see image C1)
Place the jug (3) onto the motor unit
‹
(1) with the handle to the right and
turn the blender jug clockwise until it
audibly snaps in.
If the chopping blade (7) is fitted, re-
‹
move it from the spindle attachment
(4) by pressing in the latches.
WARNING
Danger from sharp blades!
► Do not touch the blades. Always hold
the chopping blade by the plastic
shaft.
Put the spindle attachment (4) with-
‹
out chopping blade (7) onto the drive
spindle of the jug (3).
Remove the grating disc (5) or the
‹
cutting/rasping disc (6) from the ac-
cessories compartment (18) on the
back of the appliance.
Put the grating disc (5) or the cutting/
‹
rasping disc (6) onto the spindle at-
tachment (4), in the case of the latter,
with the rasper or blade edge pointing
upwards.
Put the jug lid (8) onto the jug (3) and
‹
lock it by turning it clockwise.
NOTE
► Make sure that the jug (3) and
the jug lid (8) are seated properly,
otherwise the appliance cannot be
operated (safety switch).
BEEM - Elements of Lifestyle
Fill the food to be rasped or cut into
‹
the filling shaft of the jug lid (8).
Insert the plug into the mains socket
‹
and move the rotary switch (2) to im-
pulse or continuous operation.
Push the food downwards with the
‹
pusher (9) until the filling shaft is
empty.
CAUTION
► Observe the maximum operating
time of 2 minutes.
► Allow the appliance to cool down for
1 minute.
Refilling:
Switch off the appliance.
‹
Take out the pusher (9) and fill the
‹
shaft of the jug lid (8) with more food.
NOTE
► Pay attention to the maximum filling
quantity in the blender jug (3).
► Before emptying the jug, remove the
grating disc (5) or the cutting/rasp-
ing disc (6) and the spindle attach-
ment (4).
Multi-FiXX 500
25