Troubleshooting - Beem Multi-FiXX 500 Manual De Instrucciones

Multi-FiXX 500
The following table helps in localising and remedying minor faults:
Fault
The appliance does not
work after turning the
rotary switch.
The automatic circuit
breaker in the electrical
distribution board trips.
Motor runs extremely
slowly or stops.
NOTE
► If you cannot resolve the problem with the steps described above, please contact
28

Troubleshooting

Possible cause
Plug not inserted into socket.
Automatic circuit breaker in
electrical distribution board
tripped.
The internal safety switch has
switched off the appliance as
a result of overheating.
The jug and/or the kid is not
fitted properly.
Too many appliances connect-
ed to the same power circuit.
Appliance is defective.
Jug overfilled.
Pressure too strong.
Remedy
Insert plug.
Switch on the automatic
circuit breaker again.
Allow the appliance to
cool down.
Fit and lock the jug and
lid properly.
Reduce the number of
appliances on the power
circuit.
Contact customer
service.
Remove some of the
ingredients.
Exert less pressure.
BEEM - Elements of Lifestyle
EN