GUTMANN Hermano Instrucciones De Uso página 23

Please clean the switch panel only with a soft
and damp-dry cloth.
By extractor hoods with a glass pane beneath
the metal grease filter ("Perimeter Extraction")
fatty deposits can occur on the edge of the
glass pane. These deposits are founded
physically and represent no dysfunction of the
extractor hood. Please clean the glass pane
beneath the filter regularly to prevent stubborn
soiling.
Exchange and cleaning of the
filter
Fire risk! The performance of the extractor
hood is affected by containing fat remains and
2
therefore the fire risk increases. To prevent a
fire risk please clean the metal filter regularly.
The metal grease filter must be cleaned every
2 weeks at last.
By models with a pane beneath the filter ("Pe-
rimeter Extraction") the pane has to be
removed at first. For this
front glass pane with one hand upwards and
then take the filter out at its grip.
grease filter is fixed by a magnet.
installation is made in reverse order.
1
swing at first the small
The metal
The
The metal grease filter is to be cleaned at
best in a dishwasher or in hot soapy water.
Aggressive cleaners should not be used. The
guarantee can´t be applied if a discolouring
on the filter is a result of using an aggressive
dishwashing liquid.
temperatures over 65 degrees.
Attention: do not use 3-phase-cleaners or
clean the filter in a commercial dishwasher.
The use of aggressive cleaners like fuel,
acetone, trichlorethylene destroys the filter!
Reinstate the metal filter after the cleaning.
By models using the "Perimeter Extraction"
method the pane has to be brought
afterwards in its original position. Therefore
please press the pane with both hands
upwards to a certain extent (lock in of the
pane).
Exchange of the active carbon
filter
(only extractor hoods with circular air – version D)
Active carbon filters bundle up odorous
substances which are contained in the
kitchen fume. According to the strain of work
this filter has to be exchanged after 3-6
months.
The active carbon filter is often mounted on a
frame sitting below the ventilator module. For
the exchange of the active carbon filter turn
both black toggle screws around 90 degrees.
After flapping down the pane and taking out
the frame the filter can be changed easily. The
installation is made in reverse order.
By some extractor hoods the active carbon
filter is directly mounted on the metal filter.
After the removal of the metal filters take the
charcoal filter out and substitute it by a new
one. Important: please do not clean the active
carbon filter with water or any other liquid.
Option:
Ausführung mit Carbonfilter: siehe Seite 36-37
en
Please avoid