Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
OPERATION
After you connected the effect to the mains, the Pro Flood starts running.
REPLACING THE LAMP
During the operation, the lamp reaches temperatures of up to 700° C.
Before replacing the lamp, unplug mains lead and let the lamp cool down (approx. 5 minutes).
Do only replace the lamp with a 230 V/750 W R-7-s or 230 V/1000 W R-7-s pole-burner.
Please refer to the instructions under "Installation of the lamp".
Procedure:
Step 1: Remove the colour-filter-frame.
Step 2: Unlock the protective grid and open it.
Step 3: Remove the old lamp from the lamp-socket.
Step 4: Insert the new pole-burner into the lamp-socket.
Step 5: Close the protective grid and close the lock.
CLEANING AND MAINTENANCE
We recommend a frequent cleaning of the device. Please use a soft lint-free cloth moistened with any good
glass cleaning fluid. Never use alcohol or solvents!
There are no servicable parts inside the device except for the lamp. Maintenance and service operations are
only to be carried out by authorized dealers.
Should you need any spare parts, please use genuine parts.
Should you have further questions, please contact your dealer.
TECHNICAL SPECIFICATIONS
Power supply:
Power consumption:
Dimensions (LxWxH):
Weight:
Fitting lamps:
Maximum ambient temperature t
Maximum housing temperature t
Please note: errors and omissions for every information given in this manual excepted. Every
information is subject to change without prior notice. 4/00 ©
The lamp has to be replaced when it is damaged
or deformed due to the heat!
DANGER TO LIFE!
Disconnect from mains before starting maintenance operation!
:
a
(steady state):
B
CAUTION!
230 V AC, 50 Hz ~
1000 W
355 x 210 x 255 mm
4 kg
Pole-burner 230 V/750 W R-7-s
Pole-burner 230 V/1000 W R-7-s
45° C
110° C
10
Publicidad
Tabla de contenido
