Securing The Unit To The Wall; Deciding The Position - Bosch TRONIC 3000C Pro Instrucciones De Instalación Y Funcionamiento

▶ Set the Power Selector Screw (Fig. 5 ) on the desired
setting. If it is set to LO, only one heating element will
operate and the output will be half power. See the Table
4 on page 7 for temperature rise at various flow rates. If
the element is set on HI, both heating elements will operate
and the output will be full power. When setting the Power
Selector Screw, it is important that the screw be adjusted
all the way to the end of the slot and that it be well
tightened.
Fig. 5 Power selector screw
▶ Attach the front cover and tighten the retaining screws.
4.5

Securing the unit to the wall

4.5.1 Deciding the position

▶ If being used in a public place, position the unit out of reach
to discourage vandalism.
▶ Mount the unit onto a flat section of wall, well away from
any potential splashes of water or spray.
▶ Mount only as shown in Fig. 6, Fig. 7 and Fig. 8 with the
water connections located either at the right side, left side
or bottom of the unit.
Remember to keep the lengths of hot water pipe to a
minimum in order to save energy.
▶ If the unit is to supply a sink, you can fit it either above or
below the sink.
TRONIC 3000C Pro
Fig. 6 Example of installation (front view)
[1] Hot water
[2] Cold water
Fig. 7 Example of installation (front view)
[1] Hot water
[2] Cold water
Installation | 11
6 720 647 005 (2017/05)