Danger Of Fire; Cleaning And Maintenance - EuroLite Strobe-Spot Manual Del Usuario

Please use the original packaging if the device is to be transported.
Please consider that unauthorized modifications on the device are forbidden due to safety reasons!
If this device will be operated in any way different to the one described in this manual, the product may suffer
damages and the guarantee becomes void. Furthermore, any other operation may lead to dangers like short-
circuit, burns, electric shock, lamp explosion, crash etc.
RIGGING
When installing the device, make sure there is no highly-inflammable
material (decoration articles, etc.) within a distance of min. 0.5 m.
The installation of the device has to be built and constructed in a way that it can hold 5 times the weight for 1
hour without any harming deformation.
When rigging, derigging or servicing the fixture staying in the area below the installation place, on bridges,
under high working places and other endangered areas is forbidden.
Procedure:
If the device shall be lowered from the ceiling or high joists, professional trussing systems have to be used.
The device must never be fixed swinging freely in the room.
Caution: Devices may cause severe injuries when crashing down! If you have doubts concerning the safety
of a possible installation, do NOT install the device!
Before rigging make sure that the installation area can hold a minimum point load of 5 times the device's
weight.
Do only use appropriate screws and make sure that the screws are properly connected with the ground.
Unscrew the fixation screws of the protective shield. Remove the protective shield. Remove the protective
foil from both sides of the protective shield. Replace the protective shield and tighten the screws.
OPERATION
Connect the stroboscope to the mains.
On the rear panel ot the Strobe-Spot there is a control to adjust the flash frequency (1-5 flashes per second).

CLEANING AND MAINTENANCE

The operator has to make sure that the installation is inspected once a year.
The following points have to be considered during the inspection:
1) All screws used for installing the devices or parts of the device have to be tighly connected and must not
be corroded.
2) There must not be any deformations on housings, fixations and installation spots (ceiling, suspension,
trussing).

DANGER OF FIRE!

Only operate this device with fixed protective shield!
9