Danger To Life; Replacing The Lamp - EuroLite Strobe-Spot Manual Del Usuario

3) The electric power supply cables must not show any damages, material fatigue (e.g. porous cables) or
sediments. Further instructions depending on the installation spot and usage have to be adhered by a
skilled installer and any safety problems have to be removed.
We recommend a frequent cleaning of the device. Please use a moist, lint-free cloth. Never use alcohol or
solvents!
The protective shield has to be replaced when it is obviously damaged,
so that its function is impaired, e. g. due to cracks or deep scratches!
There are no serviceable parts inside the device except for the lamp. Maintenance and service operations
are only to be carried out by authorized dealers.
Should you need any spare parts, please use genuine parts.
If the power supply cable of this device becomes damaged, it has to be replaced by authorized dealers only
in order to avoid hazards.
Should you have further questions, please contact your dealer.

Replacing the lamp

Before replacing the lamp, unplug mains lead and let the lamp cool down (approx. 5 minutes).
During the installation do not touch the glass-bulbs bare-handed! Please follow the lamp manufacturer's
notes!
Do not install lamps with a higher wattage! Lamps with a higher wattage generate temperatures the device
was not designed for. Damages caused by non-observance are not subject to warranty.
For the installation, you need one Flash-tube U-shape.
During the operation, the lamp reaches temperatures of up to 200° C.

DANGER TO LIFE!

Disconnect from mains before starting maintenance operation!
DANGER TO LIFE!
DO NOT OPEN FOR 5 MINUTES AFTER SWITCHING OFF!
DANGER TO LIFE!
Only install the lamp with the device switched off!
Unplug from mains before!
The lamp has to be replaced when it is damaged
or deformed due to the heat!
CAUTION!
CAUTION!
10